How To Reset Transfer Case Control Module
How To Reset Transfer Case Control Module. Transfer case control module no longer in control? Check that the dashboard lights are illuminated.
How to reset transfer case control module for the 4wd? Only vehicles with an nqh transfer case have all 5 switch positions. Reprogram the tccm with the latest tis software using normal sps procedures.
Car And Truck Repair And Maintenance.
Rotate it on the run position and press the gas pedal. Verify operation and that no codes are present. Reprogram the tccm with the latest tis software using normal sps procedures.
It Won’t Make Sense If You Use This Technique Without Turning.
To begin with, you must change the key position to 2. Switch on the ignition and observe the transfer case shift control indicators, you should notice a flash. The module should wake up and communicate with the tech 2®.
First Of All, You Have To Turn The Key Position.
How do you reset transfer case control module for the 4wd system? If not it won’t clear until the fault is. It doesn’t have to be an.
Refer To Transfer Case Shift Control Module Programming And Setup (Nqh) For Additional Information On Programming The Transfer Case Shift Control Module.
Check for battery and ignition voltage. You also have to diagnose the connector of the transfer case shift control switch and the ground circuit for. If a c0550 is found current or in history with or without other codes, replace the module and go to step 6.
How To Reset Transfer Case Control Module For The 4Wd?
There have been a few threads on the check 4wd light coming on, while the light is on you will not be able to select 4wd, the first step is to try and reset the transfer case control module. Check the transfer case shift control switch connector and the ground circuit for earth. Only vehicles with an nqh transfer case have all 5 switch positions.
Post a Comment for "How To Reset Transfer Case Control Module"